HP 20-Feb manual Replacing the Redundant Power Supply

Replacing the Redundant Power Supply

To replace individual power supply units:

1.Push the tab on the power supply unit to the left.

2.Remove the supply using the handle on the back of the unit and pulling outward. Support the bottom of the power supply to avoid dropping or damaging it.

WARNING Avoid touching the top surface of the power supply unit since it may be hot.

3.Install the new power supply by sliding the replacement unit into the vacant slot until it “clicks” into place.

Figure 55 Replacing Individual Power Supply Units

Chapter 5

Chapter 5 Replacing the Redundant Power Supply 169