HP 20-Feb manual Configuring the Library for Fibre Channel, Configuration

Configuring the Library for Fibre Channel

Note	When you reconfigure the library, you may also need to
	reconfigure your backup software. For more information, consult
	the documentation provided with your software.

The optional Fibre Channel controllers in the library serve as a bridge between

SCSI and Fibre Channel.

Note	It is not necessary to connect the library to its Fibre Channel
	topology (arbitrated loop or fabric) before configuration.

Configuration

Note	When Fibre Channel controllers are installed in the library,
	device SCSI IDs cannot be changed from their factory default.

Though you do not need to set SCSI IDs for Fibre Channel, you will need to configure Fibre Channel addressing.

Main Menu -> Administration -> Change Configuration -> Fibre Channel

1.Enter the Fibre Channel menu.

2.Select the level where the Fibre Channel controller you want to configure is located.

Use the [-]key to select a lower level in the library. Use the [+] key to select a higher level in the library. Select [OK] if the level is correct.

3.A message displays the following information:

—Fibre Channel controller type (LVD or HVD SCSI)

—SCSI bus status

Select [MORE].

102 Configuring the Library for Fibre Channel Chapter 3