HP 20-Feb manual Library Installation

4/40 and 6/60 Series Libraries:

Use a mechanical lift that is rated to the weight of the library, and follow the steps below to install the library.

a.Break away the edges of the packing material at the bottom of the library.

b.Use the straps to ease the library onto an appropriately rated mechanical lift. Use the lift to raise the library so that it aligns with the bottom rails.

c.Slide the library onto the lower rails. Have at least one person guide the library from the front and one person pull the library from the back, using the vertical handle (Figure 8 on page 24).

d.Remove the lifting straps once the library is partially installed. Save the straps for future use when moving the library.

Figure 8 Library Installation

Caution Do not push the library from the front. Use the handle shown in Figure 8. DO NOT pull on the handle(s) located on the back of the power supply or drive modules.

24 Installing the 2/20, 4/40 & 6/60 Series Libraries into a Rack Chapter 1