HP 20-Feb manual Moving or Shipping the Library

Moving or Shipping the Library

WARNING	Do not move the library without additional help or an
	appropriately rated lift device. The 2/20 series library weighs
	40 kg (87 lb). The 4/40 series library weighs 75 kg (165 lb).
	The 6/60 series library weighs 104 kg (249 lb). The 8/80 and
	10/100 series libraries weigh approximately 227 kg (500 lb).
Caution	To avoid damage to the library, ensure that it is in an upright
	position at all times. Never place the library on its sides.
Note	During normal operation, changes to configurations are stored
	in Non-Volatile (NV) RAM for eight days. All configuration
	settings can be permanently saved to flash memory by power
	cycling the library. This allows the settings to be recovered if the
	library is unplugged for more than eight days. If this step is not
	completed and the library is unplugged for more than eight
	days, any new settings may be lost. Before shipping the library,
	verify that the configuration settings were saved permanently by
	first powering down the library, and then powering back up to
	store the settings and to view them.

To move or ship the library:

1.Verify that all drives are empty. If a drive contains a tape, unload it. Refer to the backup software documentation, use the remote management card (see page 96), or use the front panel menu as follows:

a.From the Drive and Tape Operations menu, select Unload Tape from Drive.

b.Use the [-] or [+] keys to select the drive you want to unload.

c.Select [Unload] to move the tape from the drive to the tape’s original location (the slot it occupied before being loaded into the drive). If that slot is occupied, you will be asked to select another slot location.

54 Moving or Shipping the Library Chapter 1