HP 20-Feb Removing a Drive Module, Connection to be removed is located inside the drive module

Removing a Drive Module

Note	To preserve SCSI communications, do not loosen or remove the
	SCSI cable(s) connected to the outside of the drive module. The
	connection to be removed is located inside the drive module.

Remove the drive module using the steps below:

1.Verify the external SCSI cable is tightened to the connector plate.

2.Loosen the thumbscrews on each side of the connector plate, located in the middle of the drive module (Figure 51 on page 163). If this is your first time loosening the thumbscrews, use a screwdriver.

3.Gently remove the connector plate, with SCSI cable(s) still connected.

Caution Use standard precautions for electro-static discharge (ESD) protection.

4.Grasp the ribbon cable that is plugged into the drive module. Remove the cable by pulling the connector to the left. See Figure 51 on page 163 for the location of the ribbon cable and connector.

Figure 51 Ribbon Cable and Connector

Chapter 5

Chapter 5 Removing and Replacing Drive Modules 163