HP 20-Feb manual Set Front panel, Date and Time on

Table 18	Partial Availability Conditions
Library Status	Cause		Solution
Slave card failed	Library slave controller card failed	■	Verify that a slave card is present
	power-up test.		in all but the lowest level of the
	Note: Slave controller cards are		library.
	required in all but the lowest level of	■	Verify that the cards are properly
	the library.		seated.
		■ Power cycle the library.
		■	Contact your service
			representative.
Fibre Channel	Fibre Channel controller failed	■	Verify that proper SCSI
controller failed	power-up test. (Usually due to		terminators and/or tape drives
	problems on the SCSI bus, such as		are attached to the Fibre Channel
	an LVDS drive or terminator on an		controller.
	HVDS bus, etc.)	■	Verify that there are no bent pins
			on the controller.
		■ Power cycle the library.
		■	Contact your service
			representative.
Front Panel
Front panel not	Library could not detect the front	■	Power cycle the library.
present	panel display.	■	Contact your service
			representative.
Front panel failed	Front panel display failed power-up	■	Power cycle the library
	test.	■	Contact your service
			representative.
Miscellaneous
Date and time not	The date and time is not set on the	■	Set the date and time. (See Setting
set	front panel		the Date and Time on page 108.)
Door open	One or more tape doors are open.	■	Ensure that doors are closed.
	The library robotics will not move
	until the door is closed.

124 Understanding Error States Chapter 4