Mitsubishi Electronics 4XIXIXIXIXI Connecting System 4xi to Mitsubishi VS Projector, Config, Comm

Mitsubishi Installation Configuration and Connections

Connecting System 4xi to Mitsubishi VS Projector

[System 4￿￿model and software

versiondisplayed here]

(See note.)

(See note.)

(See note.)

(See note.)

(Note: Information depends on System 4￿￿setup.)

If the System 4xi is already configured for a Mitsubishi VS Projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration.

1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Mitsubishi VS projector. Apply power to the System 4xi and do the following:

a. Press to display the MENU SELECT on the LCD screen.

b. Press or to step to Menu 8.

c. Press to select this menu.

}d. Press or to display the configuration. The example to the left is general, yours will show the System 4xi model name, the software version and the following information:

PRJ = MITS PRJ BAUD = n/a UNIT No. = 000

HST BAUD = 9600 (value depends upon setup Menu 3)

2.Go to the procedure on page 2-3 of the System 4xi User’s Manual to remove the System 4xi cover. Then go to page 2-4 and refer to the configuration below to set up the Main Controller board. Continue with Step 3 (below) when the configuration is correct.

Config	Monitor	SW1: 1-2-3-4	SW2	SW3	SW4	SW5	SW6	Prj Cable	Comm
as									Adapter
✔	Mitsubishi VS	off-on-off-on	0	0	8	5	0	J15	26-473-01

SW3

SW2

SW4

SW5

J15

SW1

4 3 2 1

ON

3.Double-check your work and be sure the System 4xi cover is on securely.

4.Install the System 4xi in its place of operation (i.e. rack), but not powered on.

__________ Changes in some switch configurations are not detected until the power is

removed at the AC cord, and then restored.

Refer to the following connection diagram and continue.

5.The Mitsubishi VS Comm Adapter (26-473-01) has a two 9-pin male connectors. Plug the Comm Extension cable into the Comm Adapter. Plug the other end of the Comm Adapter into the “Remote 1” connector of the projector.

Extron • System 4xi Switcher Series • User’s Manual • P/N 68-401-02 Rev. C Page 4