Symptoms | Having this problem? | Check these items |
Cont. |
| • Make sure you did not plug the video cable to video |
|
| output port behind the LCD monitor TV. |
Low Quality | Picture not crisp and | • Check DVD connection |
DVD connection | some colour distortion | • Composite gives good picture |
|
| • |
|
| • Component gives best picture |
No sound | See video but no audio | • Check if the LCD Monitor volume is turned off or muted. |
|
| • Connect the audio cable securely. |
|
| • Audio cable is connected incorrectly. |
|
| • Verify that the audio source is selected correctly in the |
|
| OSD. |
|
|
|
Remote Control |
|
|
Problems |
|
|
Remote control does | No response from the | • Point the remote control directly at the remote sensor on |
not work properly | LCD Monitor TV | the LCD Monitor. |
| when remote is pressed | • Replace both batteries with new ones. |
|
| • Make sure the remote control is not disabled |
|
| (for disable/enable the remote control, please refer to the |
|
| section of Remote Control). |
Product Specific |
|
|
Problems |
|
|
DV300/DV301B 30" Multimedia Information Display
OSD Warning Messages
A warning message may appear on the screen indicating the LCD Monitor current status.
When user sees this warning message, it means that the
LCD Monitor is in adjustment process.
A warning message may appear on the screen indicating that the LCD Monitor is out of sync range.
See Specifications for the Horizontal and Vertical frequency ranges addressable by this the LCD Monitor. Recommended mode is 1280x 768 @ 60Hz.
This message means that there is no video input signal.
Screen image is too small
Cannot adjust the LCD Monitor with the buttons at the side of the unit
Image is centred | • Perform the LCD Monitor factory reset (via Menu |
on screen, but does | |
not fill entire viewing area |
|
OSD does not appear on | • Turn the LCD Monitor off and unplug the power cord and |
the screen | then plug back and power on |
| . |
The LCD Monitor is in a power saving mode (in PC mode).
For further assistance, refer to the Service Contacts list and contact your local Diamond Digital distributor.
The main OSD menu is unlocked.
The main OSD menu is locked.
51 | 52 |
