Mitsubishi Electronics EX100, ES100 user manual Menu operation

Menu operation (continued)
1 IMAGE
CONTRAST	Use to adjust the image contrast. The contrast	opt.
			XGA60
	becomes higher as the value increases.
BRIGHTNESS	Use to adjust the image brightness. The image	IMAGE
		CONTRAST	0
	becomes brighter as the value increases.
CineRichColor	Use to adjust the white level of the projected	BRIGHTNESS	0
	image. Select AUTO for normal use.	CineRichColor	AUTO
sRGB	Choose ON for projection emphasizing on the	sRGB	OFF
	color reproducibility.	COLOR TEMP.	STANDARD
	• When sRGB is ON, CineRichColor, COLOR
		COLOR	0
	TEMP., COLOR, TINT and GAMMA MODE
		TINT	0
	can't be adjusted.
		SHARPNESS	0
COLOR TEMP	Use to adjust the color temperature. See page 18.
		GAMMA MODE	AUTO
COLOR	Use to adjust the color intensity of the image.
TINT	Use to adjust the color balance of the image. The
	color balance shifts to green as the value increases and shifts to purple as the value
	decreases. (Available only when VIDEO or S-VIDEO is chosen as the source.)
	• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.
SHARPNESS	Use to adjust the image sharpness. The image becomes sharp as the value increases.
	(Not available with certain signals.)
GAMMA MODE	When AUTO is selected, the appropriate gamma mode is automatically selected
	depending on the input signal. For normal use, select AUTO. Select DYNAMIC for
	computer sources. Select STANDARD for sport scenes and video sources. Select
	THEATER for film sources.
2 INSTALLATION
AUTO POWER ON	When ON is chosen, the lamp is automatically lit
		opt.
	when the power cord is plugged in the wall outlet.		XGA60
	Choose ON when using the projector mounted on	INSTALLATION
	the ceiling.	AUTO POWER	OFF
		ON
	• The projector is in the stand-by mode when the	AUTO POWER
			OFF
		OFF
	lamp is off. Use the remote control to turn on	ON SPLASH
			ON
		SCREEN
	the lamp.
		BACK COLOR	BLUE
AUTO POWER OFF	Use to set the time elapsed before the projector
		LAMP MODE	STANDARD
	enters the stand-by mode when there is no signal
		IMAGE
			OFF
		REVERSE
	input from the source.
SPLASH SCREEN	Choose ON to display the splash screen when the
	power is turned on.
BACK COLOR	Use to select the background from among BLUE and BLACK, which will be displayed
	when there is no signal input from the source.
LAMP MODE	Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness
	is kept low and the projector operating noise is reduced, resulting in a longer lamp
	replacement interval.

•When the lamp mode is switched, the projected image may flicker. This is not a product malfunction.

•Do not change the setting of LAMP MODE frequently.

For EX100U/EX10U

• When LAMP MODE has been set to LOW, the lamp mode changes from STAN- DARD to LOW about one minute after turn-on.

For ES100U

• You can’t change the lamp mode for one minute after turning on the projector. IMAGE REVERSE................... Use to reverse the projected image. Select MIRROR for rear projection with the

tabletop-mounted projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.

EN - 16