Mitsubishi Electronics EX100, ES100 user manual Indicators, Normal condition

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.

The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.

POWER indicator

STATUS indicator

POWER STATUS

Normal condition

POWER	STATUS		CONDITION	NOTE
			Stand-by
Steady		Off
red
			Lamp stand-by (about 1 minute)	The POWER button cannot be used to
Steady	Blinking
				switch between on and off.
green	green
			The power is on. (Normal condition)
Steady	Steady
green	green

Abnormal condition

POWER	STATUS	CONDITION	POSSIBLE SOLUTION
		Abnormal temperature
Steady		• The ventilation grilles is clogged with dust or dirt.	• Clean the ventilation grilles.
green		• The room temperature is high.	• Relocate the projector to a cooler place.
or	Blinking orange
Steady red

		The protection circuit is working or the lamp is in an
Steady red		abnormal condition.
	Blinking green
		The lamp operation time exceeds the time elapsed until the
Steady	Blinking green/red	lamp shutdown notice while the power is on. (See page 22.)
green
		The lamp operation time exceeds the time elapsed until the
Steady red	Blinking red	lamp shutdown notice while the power is off. (See page 22.)

•Wait until the STATUS indicator goes out, then press the POWER button.

•If the above solution is not effective, replace the lamp.

Replace the lamp.

Change with a new lamp if this problem recurs.

				The lamp operation time exceeds the time elapsed until the
Steady red	Steady red			lamp shutdown. (See page 22.)
		Off		The lamp cover isn’t closed.	Close the cover correctly.
Blinking
green/red
				Abnormal.	Contact your dealer.
	Steady
Blinking			or
green/red	Blinking

EN - 26