Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1
1.Press the
2. Screw the rear adjuster foot to fine tune the horizontal angle.
To retract the foot, hold up the projector while pressing the
If the projector is not placed on a flat surface or the screen and the projector are | 2 | 1 |
not perpendicular to each other, the projected image becomes trapezoidal. To |
|
|
correct this situation, see "Correcting keystone" on page 24 for details.
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
•Be careful when you press the adjuster button as it is close to the exhaust vent where hot air comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the
The current source information will be displayed in the upper left corner of the screen for 3 seconds.
• The screen will be blank while AUTO is functioning.
•This function is only available when a PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
In the right figure, (A) Focus Ring, (B) Zoom Ring |
|
| |
1. | Adjust Zoom. (using (B) Zoom Ring) |
| A |
2. | For the short distance/large screen, dial the ring fully to Wide end. | Tele | Wide |
3. | For the long distance/small screen, dial the ring fully to Tele end. |
| B |
Adjust Focus. (using (A) Focus Ring) |
|
| |
4. | Move the product back and forth to adjust the screen size. |
|
|
5. | Adjust Focus again if necessary. |
|
|
ENGLISH
