Lamp information
Getting to know the lamp hour
When the projector is in operation, the duration (in hours) of lamp usage is automatically calculated by the
Total (equivalent) lamp hour
= 1 (hours used in Low mode) + 4/3 (hours used in Standard mode)
See "Setting Lamp mode as Low" below for more information on Low mode.
The lamp hour in Low mode is calculated as 3/4 of that in Standard mode. That is, using the projector in Low mode helps to extend the lamp hour by 1/3.
To obtain the lamp hour information:
1.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
2.Press 
to highlight Lamp Settings and press MODE/ENTER. The Lamp Settings page is displayed.
3.You will see the Equivalent lamp hour information appearing on the menu.
4.To leave the menu, press MENU/EXIT.
You can also get the lamp hour information on the INFORMATION menu.
Extending lamp life
The projection lamp is a consumable item that normally can last up to
Setting Lamp mode as Low
Using Low mode reduces system noise and power consumption by 20%. If the Low mode is selected, the light output will be reduced and result in darker projected pictures.
Setting the projector in Low mode also extends the lamp operation life. To set Low mode, go into the SYSTEM SETUP: Advanced > Lamp Settings > Lamp mode menu and press 
/ 
.
• When this mode is switched, the projected images may flicker.
•If this mode is frequently switched, the lamp may be deteriorated.
Setting Auto Power Off
This function allows the projector to turn off automatically if no input source is detected after a set period of time to prevent unnecessary waste of lamp life.
To set Auto Power Off, go into the SYSTEM SETUP: Basic > Auto Power Off menu and press 
/ 
. The time period can be set from 5 to 30 minutes in
ENGLISH
