Series HMI Connection Manual
b. The mode switch setting of
After PLC communication mode switch is set, please re-activate the PLC.
The protocol is CheckSum and PLC Mode is Form 4. For switch setting of other communication parameter, please refers to Mitsubishi user manual.
2)Parameter is set by the programming software GX Developer, please refers to PLC user manual for set up instruction.
3)Device address should be the multiple of 16.
4)Device address should be the multiple of 16 plus 9000.
5)When certain Output Relay (Y) and Special Data Relay (SM) are set as 1, PLC will stop function. Please RESET the PLC for
6)Though the default setting is in short communication address, this protocol supports both Short/ Long communication address. If only certain type of address is suitable to your device, address format can be changed in special parameter under the setting menu.
112 | V1.02 Revision November, 2011 |
