Mitsubishi Electronics English, Monitor Specifications, MultiSync LCD1760VM Monitor

Specifications

Monitor Specifications		MultiSync LCD1760VM Monitor	Notes
LCD Module	Diagonal:	43.2 cm/17 inches	Active matrix; thin film transistor (TFT)
Viewable Image Size:		43.2 cm/17 inches	liquid crystal display (LCD); 0.264 mm
Native Resolution (Pixel Count):		1280 x 1024	dot pitch; 250cd/m2 white luminence,
			typical; 350:1 contrast ratio, typical.
Input Signal	Video:	ANALOG 0.7 Vp-p/75 Ohms	Digital Input: DVI
	Sync:	Separate sync.TTL Level
		Horizontal sync. Positive/Negative
		Vertical sync. Positive/Negative
		Composite sync. Positive/Negative*3
		Sync on Green (Video 0.7 Vp-p and Sync. 0.3 Vp-p)*3
Display Colours		16,194,277	Depends on display card used.
Synchronization Range	Horizontal:	31.5 kHz to 81.1 kHz (Analog)	Automatically
		31.5 kHz to 69 kHz (Digital)	Automatically
	Vertical:	56 Hz to 75 Hz	Automatically
Viewing Angle	Left/Right:	±70°
	Up/Down:	±60°
Resolutions Supported		720 x 400*1 at 70 Hz	Some systems may not
		640 x 480*1 at 60 Hz to 75 Hz	support all modes listed.
		800 x 600*1 at 56 Hz to 75 Hz
		832 x 624*1 at 75 Hz
		1024 x 768*1 at 60 Hz to 75 Hz
		1152 x 870*1 at 75 Hz
		1280 x 1024*2 at 60 Hz to 75 Hz	(Analog)
		1280 x 1024*2 at 60 Hz (Digital)
Active Display Area	Horizontal:	337.9 mm/13.3 inches	Dependent upon signal timing.
	Vertical:	270.4 mm/10.6 inches
Power Supply		100 - 240 V ~ 50/60 Hz
Current Rating		0.75 - 0.4 A
Dimensions		374 mm (W) x 372.8 ~ 482.8 mm (H) x 205.0 mm (D)
		14.7 inches (W) x 14.7 ~ 19 inches (H) x 8.1 inches (D)
Weight		6.8 kg (15 lbs)
Environmental Considerations
Operating Temperature:		5 °C to 35 °C
	Humidity:	30% to 80%
	Altitude:	0 to 3,000 m
Storage Temperature:		-10 °C to +60 °C
	Humidity:	10% to 85%
	Altitude:	0 to 12,000 m
Speakers Practical Audio Output		1.0W + 1.0W

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

*2 NEC-Mitsubishi Electronics Display cites recommended resolutions at 60 Hz for optimal display performance.

*3 If your display is not showing a picture for the SOG and Composite Sync. Signal, please contact our hotline for further assistance.

NOTE: Technical specifications are subject to change without notice.

English

English-13