Mitsubishi Electronics MSZ12UN, MSZ09UN Preparation Before Opera, Auto restart function

PREPARATION BEFORE OPERA

Auto restart function

■These models are equipped with an auto restart function. If you do not want to use this function, please consult the service representative because the setting of the unit needs to be changed.

Auto restart function is ...

When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are stored in the memory. If a power failure occurs or the main power is turned off during operation, “Auto restart function” sets automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main power. (Refer to page 7 for details.)

Breaker for the air conditioner

■Turn the breaker on.

Remote controller (How to set the batteries and the current time)

Remove the front lid and insert bat-	3	Press the CLOCK set button.
1 teries. Then reattach the front lid.
Insert the minus pole of the batteries first.		Press using
Check if the polarity of the batteries is correct.		a thin stick.

Insert the minus pole of the batteries first.

2Press the RESET button.

Press using a thin stick.

■If the RESET button is not pressed, the remote control- ler may not operate correctly.

		HR.	MIN.	button
4	Press the		and
	(TIME SET button) to set the current
	time.
		FAN	STOP
	I FEEL	COOL
		VANE	START
	HEAT	DRY
	MODE		HR.
			MIN.
		RESET CLOCK
	HR.	button is pressed, the set time in-
■ Each time the
creases by 1 hour, and each time the MIN.				button is

pressed, the set time increases by 1 minute.

5Press the CLOCK set button again and close the front lid.

6