Mitsubishi Electronics Pro 920 PART NAME

- 9 -

ENGLISH

D-SUB

2.1 Control Names

See Figures 3 and 4 for the location of the user controls,

indicator and connectors.

Each part is identified by number and is described

individually.

REAR

PART NAME

FRONT

Figure 3

7. AC POWER CONNECTOR

8. SIGNAL INPUT CONNECTOR (DB9-15P)

Figure 4

2.2 Function

1. POWER SWITCH: A push-on / push-off switch for AC

power.

2. POWER-ON INDICATOR: This indicator illuminates

green when AC power is on, and illuminates amber

when the monitor is in the power management modes.

3. FPM (FINE PICTURE MODE):

Push to on/off the contrast enhancement function.

4. DOWN BUTTON: Push to select group icon.

5. ITEM SELECT BUTTON: Push to select the item icon.

6. FUNCTION ADJUST BUTTONS: Push the adjust

buttons to adjust the image on the screen.

D-SUB

Contents

Main Registration Limited Warranty CAUTION Trademark ENERGY STAR CONTENTS Page Flame retardants Cadmium Mercury CFCs (freons) Lead INTRODUCTION Never leave the monitor in contact with rubber or vinyl for an extended time period. Do not spray directly on the screen as cleaner may drip into the monitor and damage the circuitry. Keep your fingers away from the pivot area of the tilt/swivel base. REAR PART NAME FRONT INSTALLATION AND CONNECTION FUNCTIONS - 12 - Items Function A B C If a non-Factory Preset timing is used, "GEOMETRY RESET" does not work. 4.2 Adjustment Items X: Available Group Icon Icon Group Icon Icon TROUBLESHOOTING Page 6 6 SPECIFICATIONS * 7 2,4 1,2 3,4 1,2,3,4 1,2,6 <Optional Macintosh Adapter AD-A205 Setting Chart> Set the dip switch "ON" as shown below. Example; "1,2" )