Mitsubishi Electronics SA51 user manual User memory for signal setting

4SIGNAL

MEMORY CALL ........ Use to select AUTO, USER 1 or USER 2. See below.				Opt		XGA60
HORIZ. POSITION .... Use to adjust the horizontal position of the image.
VERT. POSITION ..... Use to adjust the vertical position of the image.	SIGNAL
FINE SYNC. ....... Use to synchronize the projector with PC input signals so		A	MEMORY CALL			AUTO
		U
that the image is not blurred.			HORIZ. POSITION		0
TRACKING ......... Use to avoid image noise such as wide stripes.			VERT. POSITION		0
			FINE SYNC.		0
COMPUTER INPUT .... The unit adjusts itself automatically when connected to
			TRACKING		0
either DVD players with a component video output
			COMPUTER INPUT			RGB
terminal (Y, CB, CR or Y, PB, PR) or equipment with HDTV		RRGGBB
			HOLD			AUTO
signal output capabilities. In cases where the unit is
		USER MEMORIZE			DELETE DEFAULT
connected to equipment that include an RGB output
terminal and which output HDTV signals, adjust the unit
to RGB mode.
HOLD .................. Adjusts the image when flagging near the top.

5 SIGNAL - USER (Normally, there is no need for adjustments.)

CLAMP POSITION/	SIGNAL-USER
CLAMP WIDTH ......... If you use something similar, the brighter colors of the
			CLAMP POSITION	0
projected image may become blurred. In this case, adjust
			CLAMP WIDTH	1
CLAMP POSITION or CLAMP WIDTH.
			HORIZ. PIXELS	0
HORIZ.PIXELS .. Use to adjust the width of the image. The image size
			VERT. LINES	0
grows wider as the number increases. (Adjust to the
			PLL	AUTO
horizontal pixels of the input signal for normal setting.)
		?	VERT. SYNC.	AUTO
VERT.LINES ...... Use to adjust the height of the image. The image size
			SHUTTER(U)	0
grows higher as the number increases. (Adjust to the
			SHUTTER(L)	0
vertical lines of the input signal for normal setting.)
			SHUTTER(LS)	0
PLL ...................... Use to adjust the image when skewed on top. Select
			SHUTTER(RS)	0

AUTO for normal setting.

VERT.SYNC. ...... Use to adjust the image when its motion does not run smoothly. Select AUTO for normal

setting.

SHUTTER(U) ..... Use to adjust the image when the noise etc. appears on top part of image.

SHUTTER(L) ...... Use to adjust the image when the noise etc. appears on bottom part of image.

SHUTTER(LS) .... Use to adjust the image when the noise etc. appears on left side of image.

SHUTTER(RS) ... Use to adjust the image when the noise etc. appears on right side of image.

User memory for signal setting

This projector can memorize the maximum of 2 signal menu settings.

Memorizing the setting

1.Select MEMORIZE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2).

3.Press the ENTER button.

Initialite the setting which has been changed (Default)

Select RESET in the SIGNAL menu, and press the ENTER button.

•When initializing, selection buttons will not work for about 2 - 18 seconds.

Select the user setting

Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2).

Reset the recorded setting

1.Select DELETE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2).

3.Press the ENTER button.

The recorded setting will be reset.

ENGLISH

EN – 17