Mitsubishi Electronics UD8850U, UD8900U manual Introduction, PC-controllable functions, Connection

1. Introduction

This projector can be controlled by connecting a personal computer with RS-232C terminal.

In addition, by connecting multiple projectors to each other in a daisy chain con￿guration, you can control each projector from one personal computer.

PC-controllable functions:

•Turning the power ON or OFF

•Changing input signals

•Inputting commands by pressing the buttons on the control panel and remote control

•Menu setting

[Compatibility with the former models]

To use the RS-232C commands designed for the former models of Mitsubishi projector, by inputting “00COMMAND0”, the projector responds in the same way as the former models. (No NAK is returned. For NAK response, see page 4. ID code cannot be designated at command sending.)

(For the recommended procedure to use the former command systems, see “Controlling the projector using a personal computer” for FL7000U.)

ITEM		Function		Data
	Character	ASCII code
Changing the RS-232C	COMMAND	43h 4Fh 4Dh 4Dh 41h 4Eh 44h	0	(Former command system),
command system			1	(New command system)

1.1 Connection

Important:

•Make sure that your computer and projector are turned off before connection.

•

(If you do not follow this instruction, the COM port may not function.)

the projectors or other devices made by other manufacturers are connected, operation is not guaranteed.

To connect with one projector:

To RS-232C terminal		To SERIAL IN
RS-232C crossover cable		terminal
D-SUB 9-pin	D-SUB 9-pin

To connect with multiple projectors (in a daisy chain configuration):

To RS-232C terminal	To SERIAL IN	To SERIAL OUT		To SERIAL IN	To SERIAL OUT
RS-232C crossover cable terminal		terminal	RS-232C crossover cable terminal		terminal
D-SUB 9-pin	D-SUB 9-pin		D-SUB 9-pin	D-SUB 9-pin

2