Part III: Setup
Programming the Remote Control: To Control Other A/V Products
CABLE/DBS VCR DVD | POWER | |
TV | AUDIO |
|
1 |
| 2 |
| DVD/LDP brand | Code to enter: | If your |
| Mitsubishi (DVD) | 003 | DVD |
|
|
| code is not |
| Mitsubishi (LDP) | 016, 017 | |
| listed here, | ||
| Panasonic | 250 | |
| please see | ||
| Pioneer DVD (LDP) | 252 (016, 017) | |
| page 62 | ||
| Sony | 254 | |
| for a | ||
| Toshiba | 253 | |
| complete | ||
|
|
| |
| To reset to default code, enter 000 | listing. | |
Figure 4. Programming the remote to control your DVD/ LDP.
After entering the correct codes for each position of the remote control, use the slide switch to select the product to control when an operational button is pressed. If you enter a code from the AUDIO chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
the Programming
CABLE/DBS VCR DVD | POWER | |
TV | AUDIO | 2 |
1 |
| |
Audio brand | Code to enter: | If your | |
Mitsubishi A/V receiver | Set | audio | |
and/or CD player | Set | code is not | |
listed here, | |||
Denon | 234, 235, 236 | ||
please see | |||
Kenwood | 200, 208 | ||
page 62 | |||
JVC | 232, 233 | ||
for a | |||
Onkyo | 209, 214 | ||
complete | |||
Pioneer | 205, 207 | ||
listing. | |||
Sony | 222 | ||
| |||
Yamaha | 201, 208 |
|
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V receiver.
Cable/DBS position:
Cable box
Satellite receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player [If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to either 010 or 011. Plug the CD player power cord into a switched outlet on the back of your A/V receiver. Pressing the POWER button will then turn on your A/V receiver, in turn, turning on your CD player. On select CD players, the transport controls (FF, Play, Rew, etc.) in the audio position will operate the CD player.]
If the slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.
Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.
25