Mitsubishi Electronics WD-73640 Setting Up Inputs with Auto Input Sensing, Watching Broadcast TV

81. Basic Setup and Operation

Setting Up and Using TV inputs, continued

Setting Up Inputs with Auto Input Sensing

Connection information starts on page 13. Learn more about Auto Input Sensing on page 24.

1, Power on the TV.

Power on the devices to ensure detection.

3, Connect one device to the TV, making note of the TV input jack.

The TV will display the New Device Found screen if the connection type is detectable.

4, Highlight the device type in the on-screen list and press ENTER.The name you select here will appear in the Input Selection menu.

Sample New Device Found screen,

More About the input Selection Menu

•To assign helpful names to the icons, see the Inputs > Name menu.

•To remove unwanted Antenna or HDMI device icons from the Input Selection menu, see the Inputs > Name menu.

•To rearrange the icons, use the Inputs > Order menu.

Detailed information on using these menus is in the supplemental Owner's Guide at

www.mitsubishi-tv.com.

Watching Broadcast TV

TV Connected to an Antenna or Direct Cable Service (no cable box)

Note: Perform channel memorization to enable recep- tion of digital channels. See page 7.

1, Press INPUTto display the Input Selection menu. Highlight the antenna or cable icon and press ENTER.

Press EXITto close the New Device Found screen.

&Repeat the preceding steps for each additional device you want to add.

Selecting an Input to Watch

1, Press INPUT.

Press 4 !_ and V to highlight an input icon.

Sample Input Selection menu, DVD input selected

3, Press ENTERto switch to the input.

Note: In most cases, to see a named icon for a con- nected device (as in the samples), you must first assign a name either

•When the device is first connected and the New Device Found menu offers a choice of names.

•By using the Inputs > Name menu to assign or change a name at any time after the TV has detected the connection.

Sample Input Selection menu, antenna input selected

3, To tune to a channel from the ANT input, use any of these methods.

•Enter the channel number using the number keys on the remote control and press _.

For a two-part digital channel, such as 3-1,

press3

•Press _to change channels one channel at a time.

•	Press	and	hold _to	speed	through	channels.
•	Press	_	to return	to the	previous	channel.

•Use the Fav (Favorites) feature to tune to up to nine favorite channels. See page 19.

•	Press _to	display ChanneIView channel
	listings. Highlight a channel number, then
	press _to	tune.

•Set up ChannelView custom channel banks

and use the _ key to tune within predefined groups of channels.

For assistance call 1(800} 332-2119