Mitsubishi Electronics WD3300U Setting the password (Password Setup)

EN-9
1
Enter “0” and press the Enter key.
2
Input the old (current) password and press the Enter
key. (Default password is admin.)
If you input a wrong password, an error message •
appears and the setting menu is displayed again.
In this case, set the password again.
If you forget your password, select “7 •
factory defaults,” input the password
“projectorcontroller,” and then select “9 save and
exit” to perform initialization.
3
Input a new password (example: “proj2000”) and
press the Enter key.
(Note)
Use single-byte alphanumeric characters only.
4
Input the new password (example: “proj2000”) again
and press the Enter key.
If you input a wrong password, an error message •
appears and the setting menu is displayed again.
In this case, set the password again.
Setting the password (Password Setup)
Preparation/SetUp (continued)