Power Cable Connections and Switching the Power On/Off
Finishing
1 Switch off the power of the connected equipment
2 Switch off the power of the projector
Main unit operation: Press the STANDBY button.
Remote control operation: Press the STANDBY OFF button.
ON STANDBY OFF
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen will go off (in about 5 seconds) and the projector will enter the
Note
*The operation can be cancelled by pressing a button other than the STANDBY button.
*One more press of the STANDBY (STANDBY OFF) button will switch off the power.
The STANDBY indicator changes to flash- |
|
| Lit green |
ing amber and lights a steady amber after |
|
|
|
about 60 seconds (when the unit enters the | STATUS |
| STANDBY |
| |||
| |||
standby mode). |
| ||
|
|
|
Power Off
OK ?
Power Off
OK ?
| Flashing amber |
|
|
| Lit amber | |
(Approximately 60 seconds) | Standby mode | |||||
STATUS |
| STANDBY | STATUS |
|
| STANDBY |
|
|
| ||||
|
| |||||
3 Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.
Warrning
Do not unplug the power cable while the STANDBY indicator is flashing amber. Doing so may shorten the life of the lamp or damage the projector.
