Mitsubishi Electronics XD50U user manual Start Logo Capture, Preview

Setup

Start Logo Capture

This executes image capture.

See “Startup Logo Creation” on Page E-57 for information about using logo capture.

Select item name “Logo Capture”, press the ENTER button, and the sub menu will open.

Select “Start Logo Capture” and press the ENTER button. There is a change to the capture range selection display.

Note:

Selection is not possible in the absence of a signal.

Movement of the Capture Range

Use the SELECT ￿￿￿￿ buttons on the remote control to move the red frame.

Width/Height Adjustment of the Capture Range

The MENU button will switch between the height adjustment and the width adjustment.

There is a change to the display of the selected “Adjust Capture Region Height” or “Adjust Capture Region Width”.

Adjust the capture range (i.e., red frame) with the remote control “+”/“–” but- tons.

To Cancel

Press the CANCEL button. There is a change to the menu display.

Starting Capture

Press the ENTER button start the capture.

................................Move Capture Region
Adjust Capture Region Height
Toggle Width/Height Adjustment		“MENU”
Start	“ENTER” Exit	“CANCEL”

Move Capture Region
		.................................
Adjust Capture Region Height
Toggle Width/Height Adjustment				“MENU”
Start	“ENTER”	Exit	“CANCEL”

Display for capture selection

Preview

This is used in checking the logo capture display at startup time. Selec- tion is not possible without using capture.

See “Startup Logo Creation” on Page E-57 for information about using logo capture.

Select item name “Logo Capture”, press the ENTER button, and the sub menu will open.

Select “Preview” and press the ENTER button to preview the image.

To close, press the CANCEL button or the ENTER button.

E-50