Mitsubishi Electronics XD60U Finishing, Switch off the power of the connected equipment, E-23

Power Cable Connections and Switching the Power On/Off

Finishing

1

2

Switch off the power of the connected equipment

Switch off the power of the projector

Main unit operation: Press the STANDBY button.

Remote control operation: Press the STANDBY button.

STANDBY		MENU
RGB		ENTER
VIDEO	CANCEL	QUICK
		Q
FREEZE	MUTE	LAMP MODE AUTO

1 2 3 4

ASPECT

The [Power Off] display appears.

When the level gauge reaches maximum, the projection screen will go off (in about 5 seconds) and the projector will enter the power-off op- eration.

Note

*The operation can be cancelled by pressing a button other than the STANDBY button.

*One more press of the STANDBY button will switch off the power.

Power Off

OK ?

The STANDBY indicator changes to blink- ing amber and lights a steady amber after about 90 seconds (when the unit enters the standby mode).

	Lit green		Blinking amber				Lit amber
		(Approximately 90 seconds)				Standby mode
STATUS	STANDBY	STATUS		STANDBY	STATUS		STANDBY

3 Unplug the power cable

Check that the STANDBY indicator is lit in amber and then unplug the power cable.

The STANDBY indicator will go off when the power cable is unplugged.

Warrning

Do not unplug the power cable while the STANDBY indicator is blinking amber. Doing so may shorten the life of the lamp or damage the projector.

E-23