Mitsubishi Electronics XD60U General Operation, Input Selection, E-26, When Auto Source is On

General Operation

This section describes the use of direct operation with the main unit or remote control buttons.

For information about operation using the menu, see "Menu Operation Method" on Page E-35 and the various items on Pages E-42 to E-54.

Input Selection

This operation selects the input signal to be projected.

Main unit operation: Press the SOURCE button.

(It will not function while the menu or the quick menu is displayed.)

When Auto Source is On

If there is no input signal at the source that was previously used, the projector automatically selects another source that has the next input signal.

When Auto Source is Off

Each press of the button switches the selection one step in the sequence of PC → VIDEO → S-VIDEO.

Remote control operation: Press the desired input selection button.

RGB button	This is used to switch to the PC connector.
VIDEO button	Each press of this button switches the input between Video and S-Video.

When Auto Source is On

When an input signal is not present at the selected source, the projector automati- cally selects the next source that has an input signal.

When Auto Source is Off

The projector switches to the selected source regardless of whether an input sig- nal is present.

SOURCEAUTO

MENU			QUICK
			MENU
STANDBY			MENU
RGB		ENTER
VIDEO	CANCEL		QUICK
			Q
FREEZE	MUTE	LAMP MODE AUTO
1	2	3	4
			ASPECT
VOL	KSTN	ZOOM	TIMER

Note

*When you do not operate source selection, the projector will assume the input selection condition that was previously used.

*See "Auto Source" on Page E-49 for information about the Auto Source on and off conditions.

*When the input format has been switched, you may be required to reconnect the input signal.

Automatic Adjustment of Analog RGB

This function automatically adjusts the position shift of the analog RGB input sig- nal, the size of the picture, vertical striping, and color infidelity.

Normally, this function is adjusted automatically at the time of signal selection.

Main unit operation/Remote control operation: Press the AUTO button. (This will not function while the menu or the quick menu is displayed.)

A press of the AUTO button starts the automatic adjustment.

Note

*If the display position is shifted, vertical lines appear on the picture, or the projection is not good even after using automatic adjustment, please perform image adjustment manually. See "Picture Adj. / Fine Picture / H Position / V Position " on Page E-42.

*If the position is off or there are dark vertical bands on the picture, press the AUTO button with the screen as bright as possible (make the screen as bright as possible by for example displaying the trash window over the entire screen). If the problem per- sists after pressing the AUTO button several times, set manually at the “Picture Ad- justment” menu.

*When the image extends beyond the boundaries of the screen or is smaller than the screen, set Aspect to "Auto". See "Selection of Aspect Ratio" on Page E-27 and "As- pect" on Page E-47.

SOURCEAUTO

MENU			QUICK
			MENU
STANDBY			MENU
RGB		ENTER
VIDEO	CANCEL		QUICK
			Q
FREEZE	MUTE	LAMP MODE AUTO
1	2	3	4
			ASPECT
VOL	KSTN	ZOOM	TIMER

E-26