Moen 8901 installation instructions Installation Instructions, Gooseneck Spout, Measurements

MODELS 4901, 8901 MT161A

➤

®

➤

INSTALLATION INSTRUCTIONS

	THESE INSTRUCTIONS MUST BE
	LEFT WITH HOMEOWNER
	BAR SINK FAUCET WITH
ASSEMBLY	GOOSENECK SPOUT
SPOUT

➤

➤

10-3/4"

8-1/2"

➤ ➤

Measurements

3-1/2"➤

SPOUT

NUT

ESCUTCHEON

➤

➤ ➤

WASHER

MODEL 8901
HANDLE	HANDLE
	LEVER
HOUSING
➤	➤
	ESCUTCHEON
➤
➤
➤
	SPACER
	RETAINER
	CLIP

Installs through 1-1/4" hole drillings on 4" centers. Escutcheons diameters - 1-3/4".

Supplies are 3/8" O.D. copper tubing with 1/2" male NPT nipple connedtions. Makes up to supply stops or connec tions with flexible supplies.

The spout is not a swing spout. Fasten spout escutch- eon securely before tightening the spout nut.

Equipped with flow control aerator.

NOTE: Maximum Deck

Thickness is 1/16".

Complies with ASME A112.18.1M and CSA B125

Always turn water off before disassembling the valve. Open valve

CAUTION: handle to relieve water pressure and insure that complete water shut- off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.

CLIP

EAR

EAR