Moen 84781 manual Flushing Instructions, Disassembly, Moen Lifetime Limited Warranty, INS321

Models: 84781

1 8
Download 8 pages 197 b
Page 5
Image 5
FLUSHING INSTRUCTIONS

FLUSHING INSTRUCTIONS

IMPORTANT: Pipe chips, sand, stones and other solids found in new and renovated plumbing can damage the sealing surfaces of the

cartridge and cause leaks. To avoid damage, DO NOT TURN ON SUPPLY VALVES until instructed below.

1.After installing and connecting your new faucet, make sure that the handles are in the on or open position (rotate the cold handle in the clockwise direction, the hot handle in a counter-clockwise direction).

2.Open hot and cold water shut off valves and allow the water to run for 15 seconds.

3.Turn both handles to the off or closed position (counter clockwise for cold, clockwise for hot), unscrew the aerator from the end of spout and clean any debris from the aerator screen.

4.Replace the aerator and check system for leaks.

DISASSEMBLY

1 1

2

2

14

3

3DISASSEMBLY

6

1.Use a thin bladed instrument to pry off Plug Button (1) with Color Ring (2). Remove handle screw (3). Pull handle hub (5) up and set aside.

Cartridge

Stem

2.Remove cartridge nut (14).

3.Grasp the stem of cartridge with pliers and pull straight up. This will remove the cartridge as one unit.

For reassembly, reverse the steps above.

O-ring

Seals

Valve MOEN LIFETIME LIMITED WARRANTY

Body

!CAUTION: Be careful not to damage the rubber O-ring seals when reinstalling cartridge. During installation be sure

of the following:

Stem must be in open position

Key in cartridge fits into notch on body

Start cartridge nut by hand; do not cross thread

Tighten firmly

MOEN LIFETIME LIMITED WARRANTY

CONSUMER INFORMATION

 

 

Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period” for homeowners), that this faucet will be leak and drip-free during normal use and all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship. All other purchasers (including purchasers for industrial, commercial and business use) are warranted for a period of 5 years from the original date of purchase (the “Warranty Period” for non-homeowners).

If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide the parts necessary to put the faucet back in good working condition and will replace FREE OF CHARGE, any part or finish that proves defective in material and manufacturing workmanship, under normal installation, use and service. Replacement parts may be obtained by calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address shown. Proof of purchase (original sales receipt) from the original consumer purchaser must accompany all warranty claims. Defects or damage caused by the use of other than genuine Moen parts are not covered by this warranty. This warranty is applicable only to faucets purchased after December 1995 and shall be effective from the date of purchase as shown on purchaser’s receipt.

This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due to installation error, product abuse, product misuse, or use of cleaners containing abrasives, alcohol or other organic solvents, whether performed by a contractor, service company, or yourself, are excluded from this warranty. Moen will not be responsible for labor charges and/or damage incurred in installation, repair or replacement, nor for any indirect, incidental or consequential damages, losses, injury or costs of any nature relating to this faucet. Except as provided by law, this warranty is in lieu of and excludes all other warranties, conditions and guarantees, whether expressed or implied, statutory or otherwise, including without restriction those of merchantability or of fitness for use.

Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state, province to province, nation to nation. Moen will advise you of the procedure to follow in making warranty claims. Simply write to Moen Incorporated using the address below. Explain the defect and include proof of purchase and your name, address, area code and telephone number.

Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact with the brass. The amount of lead contributed by any faucet is highest when the faucet is new. The following steps may reduce potential exposure to lead from faucets and other parts of the plumbing system:

Always run the water for a few seconds prior to use for drinking or cooking

Use only cold water for drinking or cooking

If you wish to flush the entire plumbing system of water that has been standing in the pipes or other fittings, run the cold water until the temperature of the water drops, indicating water coming from the outside main

If you are concerned about lead in your water, have your water tested by a certified laboratory in your area

HELPLINE:

1 (800) BUY-MOEN

[289-6636]

In the U.S. call our toll free Helpline number for answers to any product, installation, or warranty questions.

In Canada:

Toronto: 905-829-3400;

Rest of Canada: 1-800-465-6130

In Mexico:

(84) 88-08-26, 88-08-27,

o 91-800-84-345

Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A.

In Canada Moen Inc. • 2816 Bristol Circle • Oakville, Ontario L6H5s7

3

INS321

 

Page 5
Image 5
Moen 84781 manual Flushing Instructions, Disassembly, Moen Lifetime Limited Warranty, Consumer Information, INS321