Moen 7300 installation instructions Installation Instructions, Kitchen Deck Faucets, Measurements

7300, 8700 SERIES MT170

®

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT WITH HOMEOWNER

KITCHEN DECK FAUCETS

Single-Handle - for Eight-Inch Centers

Measurements		"FLOW-RATOR"
	9" (229mm)
	SPOUT		AERATOR

	5-3/8" (137mm)
7-1/2" (191mm)	NOMINAL
NOMINAL	(9" SPOUT)
OPEN POSITION	7-1/8" (181mm)
	NOMINAL
	(12" SPOUT)

2-1/8"	1/2" STRAIGHT
(54mm)		DECK
	PIPE THREAD
		GASKET
	MOUNTING
	NUT/WASHER

TAILPIECE NUT

FOR 8" (203mm) CENTERS

DECK ESCUTCHEON

10" (254mm) X 2" (51mm) WIDE

(DECK GASKET IS ONLY

USED WITH DECORATOR MODELS)

Complies with ASME A112.18.1M and CSA B125

Equipped with Flow-Rator® Aerator or Swing-N-Spray Aerator

Always turn water off before disassembling the valve. Open valve

CAUTION: handle to relieve water pressure and insure that complete water shut- off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.

CLIP

EAR