Monessen Hearth HVFL18 manual Connecting Remote Receiver

ELECTRICAL WIRING (MILLI-VOLT)

CONNECTING REMOTE RECEIVER

THESE INSTRUCTIONS SUPERCEDE THE SECTION ENTITLED “HEARTH MOUNT” IN THE MILLI-VOLT HAND-HELD REMOTE INSTRUCTIONS SUPPLIED WITH THE REMOTE.

1.Cut cable to length (approximately 12") for placement in the fireplace.

2.Strip back 1/4" of the insulation from both ends of each wire.

3.Connect two .25 female connectors to the wires at one end of the cable.

4.Insert the opposite end into receiver (special fitting on Ambient remotes).

5.Connect the connectors to the two .25" male connectors located on the right side when facing the unit (Figure 19). Do not let the wire touch the grate or burners.

Remote

Wire

Connectors

Remote

Receiver

Figure 19 - Installing Remote Receiver

6.Stick velcro pads with self-adhesive backing to side of remote receiver and to the right side of the unit. See Figure 19.

7.Attach remote receiver with velcro pads. Control switch must face forward.

NOTE: Heat reduces battery life. You can protect the receiver and extend battery life by mounting the receiver in a wall or other location outside the fireplace.

INSTALLING T-STAT SENSOR (OPTION SOLD SEPARATELY)

1.Remove metal bracket and label from box.

2.Peel away the paper backing on the label. Line up holes in label with holes on the bracket. Right side of label should flush with right side of bracket. See Figure 20. Press label firmly and smoothly to bracket.

3.Using Phillips screwdriver, install t-stat sensor to bracket with two screws provided. See Figure 21. Make sure the thermo bulb wire is at the bottom of t-stat sensor.

4. Plug in wiring harnesses to back of t-stat sensor. See Figure 21.	Wiring
	Harnesses
T-Stat
Bracket Sensor

T
H
E
S	R
		M
E			O
	T			S
		TI				T
				N			A
								T
					G

HIGH

Line Up

Holes

2
6
	D
		3
		3
			1
				7	L
					O
					W

T
H
	E
		R
	S		M
		E		O
			T		S
				TI			T
					N			A
									T
						G
										HI
										G
										H
26
D
	33
		17					L
									O
										W
Flush edge of label to										Thermo Bulb
right side of bracket Screws

Figure 20 - Applying Label to Bracket	Figure 21 - Installing T-Stat Sensors
	and Wiring Harnesses

59D1015 23