22 58D6002

OFF

ON

OPERATING INSTRUCTIONS

Figure 21 - Pilot
TO TURN OFF GAS TO HEATER
1. TurnON/OFFswitchtoOFFposition.
 2. Turncontrolknobclockwise toOFFpositiontocompletelyshutofftheheater.
 3. Ifapplicable:Turnoffallelectricpowertotheheater.
Figure 22 - Control Cover Plate for Milli-Volt
Hi/Lo Control
Ignitor/Pilot Control
On/Off Switch
(Located on Side
of Stove)
 1. STOP!Readthesafetyinformationlabel.
 2. Makesurethemanualshutoffvalveisfullyopen.
 3. Thisgaslogsetisequippedwithanignitiondevice(piezo)whichautomaticallylightsthepilot.Ifpiezo
ignitordoesnotlightthepilot,refertoinstructionsforMatch Lighting Instructions, page 23.
4. Turngascontrolknobclockwise totheOFFposition,turnON/OFFswitchtoOFFposition.
 5. Wait(5)minutestoclearoutanygas.Thensmellforgas,includingneartheoor.Ifyousmellgas,STOP!
FollowtheinstructionsunderWhat To Do If You Smell Gas, page 21.
6. FromOFF position, turn the gas control knob counterclockwise to IGN position. Push in
controlknobfor5seconds. NOTE: If you are running the heater for the first time, it may be
necessary to press in the control knob for 30 seconds or longer to allow air to bleed out
of the gas piping.
 7. Withthecontrolknobpushedin,pushinandreleasethepiezoignitorbuttontolightthepilot.
 8. Continuepushingthecontrolknobinforafurther10secondstopreventtheamedetectorfromshutting
offthegaswhiletheprobeiswarmingup.Releasethecontrolknob.
 9. Turngascontrolknobcounterclockwise totheONposition.
10. Afterthepilothasbeenlitforoneminute,theburnerscanbeturnedon.TurntheON/OFFswitchtoON
position.
11. Ifthegaslogswillnotoperate,followtheinstructions“ToTurnOffGasToHeater”belowandcallyour
servicetechnicianorgassupplier.
MILLI-VOLT CONTROL LIGHTING INSTRUCTIONS