9.Mains Power Switch
The Mains Power Switch should be switched to the ‘Off’ position when the RS W12 will not be used for extended periods. The switch must be in the ‘On’ position for the
10.IEC Mains Power Connector/ Fuse Location
The RS W12 is supplied with a
11.Volume Control
This control allows the level or volume to be adjusted in order to achieve a balanced overall sound. To use this facility you will need to play a selection of familiar music or film excerpts. Start with the volume at minimum and increase the level control until a balanced sound is established. If using an A/V processor or A/V receiver amplifier, the system can adjusted by the test tone function within the
12.EQ 1 setting
The EQ 1 setting should be set as a default option. This will provide the best overall transient response and power output. This setting will provide a maximally flat response suitable for music or Music video. Note: Frequency roll off starts at 27Hz
13.EQ 2 setting
The EQ 2 setting should be used when an emphasis in the low frequency is required. An additional boost of 4dB will be provided at 21Hz to give impact essential for action movies.
The EQ1 and EQ2 settings can also be adjusted to suit personal taste. This is done by pressing the buttons located on the control panel.
10
© Monitor Audio 2005 RS W12 Rev 1