Monster Cable PRO 5100 owner manual Outlet Programming

Outlet Programming

All outlets on the rear panel are programmable. To set up each outlet pair, use the front panel “MENU” and “SET” buttons to choose between “Switched On”, “Switched On After Delay” and “Unswitched (Always On)” independently for each outlet pair. You can change the settings, whenever you like. Using the outlet pair labeled “ISOLATED ANALOG AUDIO FILTERED OUTLETS” as an example, the following diagrams illustrate how it’s done:

A)Power up the PRO 5100: Press the “ON/OFF” switch one time to power the unit and start the process. Once the PRO 5100 is on, the display will show the AC line voltage.

Note: The power-on process may take up to 60 seconds since any outlet pair can be configured as “Switched on After Delay”. You can see any outlet pair’s power status LED on the front panel (refer to page 6)

B)Set Outlet Pair to “Switched On”: Press “MENU” until the second line display shows the status of the ANALOG AUDIO 1 outlet pair. Press the "SET” button until the time delay changes to “0” (zero).

The “0” (zero) time delay setting indicates “Switched On” mode for the AUDIO outlet pair. This pair will be live once the PRO 5100 is powered up by pressing the front panel “ON/OFF” button, or once triggered by an external signal.

10