31
Remove 2 screws in yoke and keeper then cross pin (see insert). Remove 3 screws with keyhole slots from top of fan.
34 | Hands free hook |
Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #10.
37
Slide remote receiver into mounting bracket.
40 Blade plate
Align the blade and then the blade plate with castings on motor to attach blades to motor.
| 32 |
| Center | Canopy |
|
| |||
|
|
| ||
|
|
| Hole | Larger |
|
|
|
| holes |
| Smaller |
| ||
| holes |
| ||
Place canopy on top of the fan motor allowing the yoke, wires and safety cable to pass through the large hole in the center of the canopy. Align the 3 larger holes around the center hole with the 3 screws still installed in the fan. Install 3 screws removed into small holes in canopy to make it a flush mount canopy and tighten screws securely.
35
white black
Make wiring connections as indicated above. White from fan to white from remote marked N. Blue from fan to blue from remote marked light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
38
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the
41
Loosen 2 screws with key slots and remove 1 screw without slot from motor plate and save screw.
33
Install two screws corresponding with the “L” shaped holes in the canopy only part way so that canopy can twist into place.
Remove the all thread studs from the lower part of the mounting bracket.
36
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
39
Lift fan to mounting bracket, aligning the “L” shape holes with the scresws on the mount- ing bracket. Turn the fan clockwise to lock in position. Install the other two screws and tighten securely.
42
Install light plate by twisting plate with key hole slots into place. .
