7
Tighten both yoke set screws to further secure downrod.
10
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
13
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two screws provided.
8
| Carefully lift fan assembly onto mounting brack- |
| |||||||
|
| ||||||||
| et. Rotate fan so that the notch on the ball |
| |||||||
| engages the ridge in the mounting bracket. This |
| |||||||
| will allow |
|
|
|
|
| |||
| 11 |
| House |
|
| Fan | Black |
|
|
|
|
|
|
| |||||
| Black |
|
|
|
|
|
| ||
|
|
|
|
|
|
| Blue |
|
|
| White |
|
|
|
| White |
|
| |
| Green |
|
| Green(downrod) | |||||
|
|
|
|
|
Green(Bracket)
For pullchain controls, follow diagram above. Make sure that all exposed wiring is secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire. After wiring is conplete, gently push wires into junction box with wire nuts pointing upward. Refer to point 3 of safety tips.
14
Install blade arms using screws and washers provided. Tighten securely. Repeat for all 5 blades.
16
9Safety cable installation
Safety Cable
Lag Screw
safety cable
|
| washer |
|
| ||
| 3” lag | lock |
|
| ||
| screw | washer |
|
| ||
| For | Canadian | installation and for USA fan and |
| ||
|
| |||||
| light | kit combinations over 35 lbs, in both flush |
| |||
| and downrod mode the safety cable must be |
| ||||
| installed into the house structure beams using |
| ||||
| the 3” lag screws,washers, and lock washers. |
| ||||
| provided. Make sure that when the safety cable |
| ||||
| is fully extended the leadwires are longer than |
| ||||
| the cable and no stress is placed on the lead- |
| ||||
| wires. |
| ||||
| 12 |
|
|
|
|
|
|
|
|
|
|
| |
|
|
| Light Switch | Fan Switch |
|
|
|
|
|
|
| Wall |
|
|
|
|
|
| Control |
|
For control of fan and optional light from wall location, follow diagram above. NOTE: A profes- sional electrician is recommended for this type of installation.
15
Check the motor for plastic shipping stabilizer tabs, and remove them if they are present. Attach blade assembly to motor using the motor screws and washers provided. Tighten screws securely.
After attaching blades install the switch housing using the three screws previously removed.