7
Lift mounting neck to mounting Plate and align screws.
8
Secure mounting neck to the mounting plate with four screws to become a complete mount- ing bracket.
9
Install 6 15 watt candelabra bulbs included.
10
Loosen 4 screws in motor housing then lower metal disk with glass onto fan by aligning 4 key slot holes in metal housing with 4 screws in fan housing. Tighten the 4 screws securely.
11
Install canopy and yoke cover over the down- rod.
12
Tread leadwires and safety cable through the downrod.
13
Place downrod into the yoke, align the holes in the yoke with the holes in the downrod and install cross pin.
14
Install keeper pin into cross pin.
15
Tighten set screws to hold downrod securely in the yoke. Drop cover over yoke.
16
Hang assembled fan from the mounting bracket installed to ceiling. Make sure the fan is hang- ing straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
17Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
18
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
