19
Place ball on downrod. Replace pin removed earlier and pull ball up so that the pin fits in the notches in the ball.
22
Raise fan with downrod assembled to the ceiling bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball.
25
white black
Make wiring connections as indicated above. White from fan to white from remote marked N. Blue from fan to blue from remote marked light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
28
Attach blade arms to blades using the blade arm screws and washers provided.
20
Tighten set screw to hold ball in place.
23Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
26
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
29
Check the motor for plastic shipping sta- bilizer tabs and remove if they are pres- ent. The screws, washers and motor pads are
21
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
24
Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position. See Fig 42 for remote operation
27
Lift canopy to ceiling aligning the key hole slots with the screws on the bottom of the mounting bracket. Rotate the canopy counter clockwise to lock in place. Tighten the screws to secure the canopy. See inset for keyhole shape
30
Loosen 2 screws and remove 1 screw. Save screw removed.
