7
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
10
Fan | House |
white | white |
Red | black |
Green
Make wiring connections as indicated above. White from fan to white from remote marked N. Blue from fan to blue from remote marked down light. Black from fan to Red from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
13
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two screws provided.
16
Loosen the 2 screws with key slots and remove the screw without key slot. Take plate and place over the 2 screws with key slots and twist to hold in place. Tighten the 3 screws securely holding the plate for the switch hous- ing.
8
Carefully lift fan assembly onto mounting bracket. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow
11
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
14
Install 3 allen screws, washers, and nuts per blade and tighten securely with allen wrench. Repeat for all 5 blades. Curve of blade goes down which is labeled on blades.
17
Plug white wire from fan to white wire from light kit. Then plug black from fan to black from light kit.
9
Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position. See Fig 25 for remote operation
12Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the lead- wires.
15
Check the motor for plastic shipping stabilizer tabs, and remove them if they are present. Attach blade assembly to motor using the motor screws and washers provided. Tighten screws securely. Next attach light kit or blanking plate to the fan.
18
Install the 2 50 watt halogen bulbs. Do not touch bulb surface as oily residue from skin can cause the bulb to explode.
