7
Align hole in downrod with hole in yoke and install cross pin.
8
Install cotter pin into cross pin.
9
Tighten the 2 set screws on the yoke once the downrod is in place. Then tighten locking nut.
10
Push yoke cover down.
11
Install 4 Max. 25 watt candelabra base bulbs into the sockets on top of the fan as shown.
12
Attach blade brackets to blades using the blade bracket screws and washers provid- ed.
13
Install upper glass to top of fan.
14
Install 3 screws and clips to hold glass to fan housing.
15
Mounting bracket slides open and shut by turning fan after hanging.
16Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws pro- vided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
17
screw holes 
screw
After sliding bracket shut place the 2 screws in screw holes and turn only a few rounds to hold in place. Make sure you put the canopy on downrod before you hang fan.
18
Place canopy over ball and downrod.
