19
Raise fan with downrod assembled to the ceiling bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball and the bracket slides shut.
20
With the bracket shut (see # 23) start the two screws do not tighten at this time.
21
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
22
Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position. See Fig 37 for remote operation
23
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
24
|
|
| House |
Fan |
| ||
|
|
| white |
white |
| ||
black |
| black | |
orange |
|
| |
blue |
|
| |
|
| Green | |
Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
25
Lift Canopy to ceiling aligning the key hole slots with the screws on the bottom of the Mounting bracket. Rotate the canopy Counter Clockwise to lock in place. Tighten the screws to secure the Canopy. See inset for Keyhole shape
26
Check the motor for plastic shipping stabi- lizer tabs and remove them if they are present. The screws, washers, and motor pads are
27
Remove inspection plate from light kit pan.
28
Find wires from lower light and fan body. Plug wires together as follows. Connect blue wire from fan to black wire from light. Connect white wire from fan to white wire from light.
29
Remove one screw and loosen the other two screws.
30
Lift light kit pan to the fan motor assembly. Align the 2 screws with the key slot holes in the light kit pan (see insert). Rotate the light kit pan as shown. Then install the screw removed in the previous step through the closed hole. Tighten all 3 screws securely.
