19
downrod
canopy | yoke cover |
|
Thread wires and safety cable from fan through yoke cover, canopy and downrod.
22
Install cotter pin into cross pin to secure.
25 Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
28
Plug in the 3 light bulbs by aligning the 2 prongs on bulb with holes in socket and then push in and twist the 50 watt bulbs which are GU10.
20
Loosen the 2 yoke screws.
23
Tighten both yoke set screws to further secure down- rod.
26
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
29
Use caution with the sloted fitter arms, do not force the fitter arms. Align the 3 sloted arms with the 3 screws in glass.
21
Align holes in downrod and holes in yoke and install cross pin.
24
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Use caution when hanging fan not to hold by blades |
| |||||||||||
|
| ||||||||||||
| are put any pressure on blades or blade arms. This |
| |||||||||||
| could create problems of blade pitch deviation, |
| |||||||||||
| deforming blade arms, or scratching of |
| |||||||||||
| blades.Carefully lift fan assembly by fan body onto |
| |||||||||||
| mounting bracket. Rotate fan so that the notch on the ball |
| |||||||||||
| engages the ridge in the mounting bracket. This will allow |
| |||||||||||
|
|
|
|
|
|
|
| ||||||
| 27 |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| ||
|
| Black |
| House |
|
|
| Fan |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| Black |
| |||
|
|
| White |
|
|
|
|
| White |
| |||
|
|
| Green |
|
|
|
|
| Green(downrod) |
| |||
|
|
|
|
|
|
|
|
|
| Green(Bracket) |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Make wire connections as per above diagram. Connect the white wire from the fan to the White or Neutral wire from the power source. Connect the black wire from the fan to the Black or hot wire from the power source. Connect all Green / Yellow wires from the fan, Downrod and mounting bracket to the Ground wire from the house.
30
When alligned push screw in glass into the slotted arm from light kit.