19

Place ball on downrod. Replace pin removed earlier and pull ball up so that the pin fits in the notches in the ball.

22

Raise fan with downrod assembled to the ceiling bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

25

 

 

 

 

 

 

Fan

 

 

House

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

fuses

 

 

 

 

white

 

white

 

 

 

 

 

 

 

 

 

 

 

 

black

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

orange

 

black

 

 

 

 

 

 

 

 

 

 

 

 

 

blue

Green

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.

28

Attach blade arms to blades using the blade arm screws and washers provided.

20

Tighten set screw to hold ball in place.

23Safety cable installation

Safety Cable

Lag Screw

safety cable

washer

3” lag lock screw washer

Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.

26

Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box and ungrounded conductor on the other side of the outlet box.

29

The screws, washers and motor pads are pre-installed to the blade holders. Attach blade assembly to motor and tighten screws securely.

21

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.

24

Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position. See Fig 42 for remote operation

27

Lift canopy to ceiling aligning the key hole slots with the screws on the bottom of the mounting bracket. Rotate the canopy counter clockwise to lock in place. Tighten the screws to secure the canopy. See inset for keyhole shape

30

Loosen 2 screws and remove 1 screw. Save screw removed.

Page 4
Image 4
Monte Carlo Fan Company 5WCR56XXD owner manual Safety cable installation