7
Check the motor for plastic shipping sta- bilizer tabs and remove them if they are present.
8
Hang assembled fan from the mounting bracket installed to ceiling in previous steps. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
9Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” lag lock screw washer
For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the lead- wires.
10
House
Black
White
Ground
Fan
Blue
Black
White
Green
11
12
Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to
Safety Tips section of manual.
13
Attach blade brackets to blades using the blade bracket screws and washers provided.
16
Install switch housing to light kit by turning clockwise to tighten.
Make wire connections to power source using wire nuts provided. Make sure that no filiments are out- side of the wirenut. After making the wire connec- tions, the wires should be spread apart with the grounded conductor and the
14
The screws, washers, and motor pads are
17
Install keeper nut over lead wires.
Lift canopy to ceiling aligning the key hole slots with the screws on the bottom of the mounting bracket. Rotate the canopy counter clockwise to lock in place. Tighten the screws to secure the canopy. See insert for key hole shape.
15
Remove the 3 screws in round holes. Remove cap by twisting and pulling down. Save screws.
18
Tighen keeper nut onto threaded pipe from the light kit.