FIGURE 9.
Plastic
Bushing
in Dash
Panel
|
|
| ._~ |
|
| |
ClevisPin (J) ~ |
| "' | \ :;;;./ | Upper | ShaftSteering |
|
~! | ,: | I | Cotte: | (K) | ||
|
| Steering |
| |||
| , | I |
| ;..~~ | Shaft |
|
|
|
|
| .,..- |
|
|
lr-::"~
lr-::"~
~J
--~
~J--~FIGURE 10.
Push the locking end of cable tie (I) through~the hole in the left frame as shown in figure 9.
Route 1he battery drain tube back to the cable tie. Place end of cable tie through the slot so a loop is formed around the drain tube to secure it. Tighten cable tie and cut off excess end.9.
Plug the green safety wire into the switch
beneath the transmission cover. Refer to figure 6. Replace the transmission cover and gear shift knob.
STEERING WHEEL INSTAllATION
1.For shipping purposes, the upper steering shaft is pushed all the way down over the lower steering shaft. Pull the upper steering shaft up. The three holes in the shaft provide three steering wheel heights. Select desired hole and secure with clevis pin (J) and
(K). See figure 10.
2.Attach steering bellow (D) to the
NOTE
One end of the steering bellow is slightly larger than the other. The larger end must be assembled to the steering wheel.
FIGURE 11.
8
~8....t
