6.0 Installation Instructions
This chapter describes the installation methods and the
The
Each step of the installation instructions must be followed. Do not skip any step unless directed to do so.
Throughout these instructions, the use of
Note
The sample console output presented throughout these instructions was produced on a VM/ESA Version 2 Release 3 system. If you're installing Tivoli ADSM for VM on a different VM/ESA system, the results obtained for some commands may differ from those depicted here.
6.1 VMSES/E Installation Process Overview
The following is a brief description of the main steps in installing Tivoli ADSM for VM using VMSES/E.
Plan Your Installation
Use the VMFINS command to load several VMSES/E files from the product tape and to obtain Tivoli ADSM for VM resource requirements.
Allocate Resources
The information obtained from the previous step is used to allocate the appropriate minidisks (or SFS directories) and the user ID needed to install the Tivoli ADSM for VM program product.
Install the Tivoli ADSM for VM Product
Use the VMFINS command to load the Tivoli ADSM for VM product files from tape to the test BUILD and BASE minidisks/directories. VMFINS is then used to update the VM SYSBLDS file used by VMSES/E for software inventory management.
Place Tivoli ADSM for VM Files into Production
Once the product files have been tested and the operation of Tivoli ADSM for VM is satisfactory, they must be copied from the test BUILD disk to the production BUILD disk.
Copyright IBM Corp. 1992, 1999 | 13 |