IBM 5697-VM3 manual IPL CMS Parm Filepool Newpool

2 Change the password for 5654A09A from xxxxxxxx to a valid password, in accordance with your security guidelines.

3 If you intend to use an SFS directory in place of the 191 minidisk for the 5654A09A user ID, the IPL statement must include the values "PARM FILEPOOL poolid:" (poolid is the name of the SFS Filepool where 5654A09A is enrolled). For example:

IPL CMS PARM FILEPOOL NEWPOOL:

This will cause CMS to automatically access 5654A09A's top directory as file mode A.

4 Include MDISK statements for the test BUILD disk (default virtual address 4E2) and for the production BUILD disk (default virtual address of 491) in the directory definition for 5654A09A. Refer to Figure 8 on page 11 to obtain the minidisk requirements for these two disks.

Note: These minidisks must be formatted before installing Tivoli ADSM for VM.

5 Add the 5654A09A directory definition to the system directory.

Note: Updates to the CP system directory can be done only from authorized user IDs. If you or any of your user IDs do not have the proper authority, then seek help from the person who has the proper authority.

6 Place the new directory definition on-line using VM/Directory Maintenance (DIRMAINT) or an equivalent CP directory maintenance method.

7 An SFS install will also require the following steps:

a Determine the number of 4K blocks that are required for SFS directories by adding up the 4K blocks required for each SFS directory you plan to use.

If you intend to use all of the default Tivoli ADSM for VM SFS directories, the 4K block requirements for each are summarized in Figure 8 on page 11.

This information will be used when enrolling the 5654A09A to the VMSYS filepool.

b Enroll user 5654A09A in the VMSYS filepool using the ENROLL USER command:

ENROLL USER 5654A09A VMSYS: (BLOCKS blocks

where blocks is the number of 4K blocks that you calculated in the previous step.

Installation Instructions 21