IBM 5697-VM3 manual Whats Next?

continue with these procedures until a R/W link is established to the 51D minidisk.

What's Next?

Beginning with VM/ESA Version 2 Release 4.0, Tivoli ADSM for VM 3.1.2 is pre-installed, using VMSES/E, in a DISABLED state, on the VM/ESA System DDRs. If, and only if, you have a license for Tivoli ADSM for VM 3.1.2, you can enable it for use. If you are

running on VM/ESA Version 2 Release 4.0

optionally installed Tivoli ADSM for VM from the VM/ESA System DDRs, and

are licensed for Tivoli ADSM for VM

then continue with step 4.

Otherwise, continue with step 6 on page 16.

VM/ESA Version 2 Release 4.0 Licensed Users of Tivoli ADSM for VM only!

4 Set Tivoli ADSM for VM to the enabled state.

vmfins enable ppf 5654A09A {ADSM ADSMSFS} Use ADSM if installing using minidisk or ADSMSFS if installing using Shared File System directories.

This command will perform the following:

Set Tivoli ADSM for VM as ENABLED in

VMSES/E and within CP.

Create a 5654A09A PRODSYS file on the A-disk that contains the CP system configuration PRODUCT statement with a state of ENABLED

5 In order to retain the ENABLED state for Tivoli ADSM for VM, update the CP system configuration file with the information in the 5654A09A PRODSYS file.

The 5654A09A PRODSYS file was created by VMFINS in the previous step. You need to update the CP system config file so that the next time you IPL your system Tivoli ADSM for VM will be in the ENABLED state. If you are not authorized to update the CP system configuration file then contact your CP System Administrator.

The CP system configuration file default name is SYSTEM CONFIG and it resides on the CP parm disk (MAINT's CF1 and CF2 minidisks). The section, PRODUCT ENABLE/DISABLE INFORMATION, in the SYSTEM CONFIG file,

Installation Instructions 15