IBM 5697-VM3 manual Apply the Service, Vmfapply ppf 5654A09A Adsm Adsmsfs, Vmfview apply

7.2.3 Apply the Service

1 Apply the new service.

vmfapply ppf 5654A09A {ADSM ADSMSFS}

Use ADSM for installing on minidisks or ADSMSFS for installing in Shared File System directories.

This command applies the service that you just received. The version vector table (VVT) is updated with all serviced parts and all necessary AUX files are generated on the alternate APPLY disk.

You must review the VMFAPPLY message log if you receive a return code (RC) of a 4, as this may indicate that you have local modifications that need to be reworked.

2 Review the apply message log ($VMFAPP $MSGLOG). If necessary, correct any problems before going on. For information about handling specific error messages, see VM/ESA: System Messages and Codes, or use on-line HELP.

vmfview apply

Note

If you get the message VMFAPP2120W then re-apply any local modifications before building the new Tivoli ADSM for VM. Refer to chapter 7 in the VM/ESA Service Guide. Follow the steps that are applicable to your local modification.

The following substitutions need to be made:

esalcl should be 5654A09A

esa should be 5654A09A

compname should be ADSM or ADSMSFS (minidisk or SFS)

appid should be 5654A09A

fm-applyaltshould be the fm of 4A6

If you have changed any of the installation parameters through a PPF override, you need to substitute your changed values where applicable.

Keep in mind that when you get to the "Return to the Appropriate Section to Build Remaining Objects" or "Rebuild Remaining Objects" step in the VM/ESA Service Guide, you should return back to this program directory at 7.2.4, “Update the Build Status Table” on page 32.

Service Instructions 31