RN40704 MUK Rev3:RN40704 MUK Rev3 19/02/2009 15:51 Page 5
Temperature control B
| Spray C | B |
|
Plug in the iron and switch on. Set the temperature control dial
‰to the required temperature, but don’t start ironing immediately.
If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with a temperature indicator light · which will go on and off while you are ironing.
This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen.
It is always a good idea to begin with cool fabrics and work up to higher settings.
An iron heats up quicker than it cools down, so you’ll save time and electricity.
FEATURES OF YOUR IRON
Temperature indicator light
The indicator light · shows that the iron is warming up. When the required temperature is reached, the light will go out and will cycle
Dry ironing
You can use your iron as a dry iron only. Make sure the variable steam control › is set to the ‘0’ symbol.
Any temperature setting may be used depending on the garment. The spray feature may be used, providing there is water in the tank (see the ‘Filling’ section on page 4). You do not need to put any water in the tank when dry ironing only.
Press the spray button fl and aim the spray of water at stubborn creases. You can do this whilst dry ironing, providing there is water in the tank. When using the water spray, it may be necessary to push the button a few times to get the spray pump primed.
Variable steam D
Fill the iron with water (as described in the ‘Filling’ section on page 4) and insert the plug into the electrical socket.
The steam output can be varied from low to high by moving the variable steam control D. When using the iron at 2 dot, the steam output should be adjusted to the low setting.
The steam facility should only be used on garments which are suitable for ironing at 2 and 3 dot setting.
Shot of steam E
Press the shot of steam button fi to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc.
The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range.
Do not use the shot of steam at temperatures below the steam range shown on the control dial.
Note: For optimum steam quality, do not operate the shot more than three times in succession.
C
D
Lower steam
Higher steam
E
For details of other Morphy Richards products, please see our website: | 5 |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
