47160 rev3_Layout 1 02/09/2011 13:57 Page 6
Using the Steam Wand to dispense hot water
4
Follow steps 1,2,3 of ‘Making espresso coffee’ on Page 3. Then refer to the following.
5
Slide the On/Off Switch (10) to On. The Espresso Temperature Indicator Light (9) will stop flashing when the coffee maker is ready.
6
Place an empty mug under the Steam Wand (2). Turn the Steam Control (1) to Steam.
When done, turn the Steam Control to Off BEFORE removing the mug from underneath the Steam Wand.
Before first use
•Take your coffee maker out of the box and remove the packaging.
•Wash the detachable parts of the machine in warm soapy water.
•The first time you use your coffee maker, operate the coffee maker with water only.
•Occasionally air locks can be present before first use. Please refer to troubleshooting guide (page 9) to resolve.
Adjusting the espresso memory function
The coffee maker can dispense two different amounts of coffee. The coffee maker comes with the following amounts set as the default settings.
One Cup - 50ml
Two Cup - 100ml
You can adjust these amounts for your own personal preference by following these steps, (Up to a maximum of 150ml for One Cup and 250ml for Two Cup.)
1Set up the coffee maker as normal following steps
2Slide and hold the Espresso One Cup (6) or Two Cup (7) Switch and keep pressed until the coffee maker has dispensed the desired amount of coffee.
3Release the switch to set the new dispensing amount.
The new setting will be stored even if the coffee maker is unplugged from the mains.
It is not possible to reset the amount back to the original dispense amount. To adjust the amount of coffee dispensed, repeat the adjustment process again to create a new dispense amount.
6