Morphy Richards 73281 OPERATING THE APPLIANCE Assembly, Hose clip fitting D, Cord Storage, Using

73281 rev1 13/3/08 16:22 Page 4

A

B

ë

C

D

E

OPERATING THE

APPLIANCE

Assembly

WARNING: Do not plug in the cleaner until it is assembled.

1Carefully unpack all of the components.

2Lift the cleaner body to the upright position.

3Slide the telescopic tube Ü into the opening on the top of the unit. Ensure the telescopic tube fits in correctly, and is locked into place A.

•To remove the telescopic tube, press the release button ë, located on the rear of the vacuum cleaner, then lift the telescopic tube up B.

4Slide the handle Ú into the top of the telescopic tube. Ensure the handle locking pin Û fits in place C.

•Remove the handle by pressing the locking pin, then pulling the handle up.

5To increase the height of the handle, push downward on the handle height adjuster button ç and raise the handle to the desired height. With the handle at the desired height, release the button, the handle will click securely into place.

Hose clip fitting D

1Using a cross-head screwdriver, remove the hose clip screw from the rear of the product.

2Insert the hose clip å into it’s slot in the rear of the appliance.

3Re-fit the screw and tighten. Do not overtighten.

Hose

Locate the hose under the hook and into the hose clip.

WARNING: Do not overstretch the hose, otherwise there is a risk of the product being pulled over.

Cord Storage

This appliance features convenient cord storage. Wind the power cord é around the two cord holder cleats è on the side of the unit. Turn the upper cord cleat to the left or right to quickly release the power cord.

USING

Unwind the power cord fully. Plug the cord into the supply mains. Press the ON/OFF button î to turn the vacuum cleaner on and off.

Release the handle by pushing the upright release pedal í. This allows repositioning of the handle for storage, normal operation or cleaning beneath furniture E.

Floor nozzle height adjustment

Before using the cleaner, the floor nozzle height must be set to the correct height.

Choose the setting which most closely matches your carpet height, using the floor nozzle height adjustment dial á. This raises and lowers the brushbar to suit your carpet type.

When the cleaner is in it’s upright position, or when using the hose Ý and tools â ã ä, ensure the floor nozzle height adjustment dial is at the tools setting.

4 UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119